I keeping getting an error when trying to upgrade the default CDS 1.0 Enviroment via the Admin Panel, it just shows a message failed to create test database?
Does anybody have any ideas? i have apps created in CDS 2.0 Environment that i want to move to the default environment and the experimental connector is also only available in CDS 1.0 Enviroments?
Could you please share more details about the error message when you upgrade your CDS data source?
Currently, I could not reproduce your issue on my side.
More details about upgrading CDS 1.0 to CDS 2.0, please check the following articles:
In addition, please take a try to fix your issue based on the resolutions mentioned within the following article:
If the issue still exists, please consider take a try to submit an assisted support ticket through the following link:
Thank you for your response, I have gone through all articles available as well as the troubleshooting, i have been attempting this for over a week now, my problem is i do not receive any errors or any further information other than the error message as shown:
I will open a support ticket see if they can see anything.
I did open a support ticket yes, they are currently looking at my environment now to see what the problem is, they did state that it is a fairly new feature that so may take sometime to get right.
Unfortunately no, this is still an ongoing issue which MS are working to resolve, i do still have an open case with them.
Fortunately for me my primary apps are in a secondary environment so i could technically delete the default database and start again but i have test data in there that i would ideally like to keep.