Hi Everyone,
I have created a flow which will run, whenever a new record is created in my SP List.
The flow sends an email to the approver which was selected in PowerApps and then if it accepts then the SP, Request Status will be updated to Approved from pending same goes for the reject.
but when the flow runs and the Email shows weird values.
Check the ScreenShots for Flow and Email and SP List
SP List:
Start and Wait for an Approval Step > Details:
Condition:
Email > When a Request Generated:
After Approve:
Accepted Solutions
On the sharepoint edit the column as below
If this post helps you with your problem, please mark your as Accepted solution.
If you like my response, please give it a Thumbs Up.
MG (Naturally Curious)
On your email step can you set the below property to Yes
If this post helps you with your problem, please mark your as Accepted solution.
If you like my response, please give it a Thumbs Up.
MG (Naturally Curious)
Hi @Mira_Ghaly ,
Few things sorted out, but the description still shows html code also in the email.
However, the description is the Text Input and I have converted it into
PlainText(ThisItem.Description).
but it's still showing that html code there
Email:
On the sharepoint edit the column as below
If this post helps you with your problem, please mark your as Accepted solution.
If you like my response, please give it a Thumbs Up.
MG (Naturally Curious)
Helpful resources
Microsoft 365 Collaboration Conference | December 7–9, 2021
Join us, in-person, December 7–9 in Las Vegas, for the largest gathering of the Microsoft community in the world.
