I'm using the "Start approval when a new item is added" template -- is it supposed to send an email requesting approval? Nothing is being sent by the workflow. I found the sent/received under Approvals dashboard but no associated email. I checked with our Exchange admin and confirmed nothing in quarantine (in case outside email is blocked). Are there any other reasons why an email is not sent, if it supposed to send one?
I also tried below and enabled notification -- still no email:
If the recipent is using the new outlook have the m check the other column and not just the Focused tab. Have them also check Junk mail. I've seen those emails end up in both in certain occasions.
Beyond that is you Exchange on-premises or Office 365? And is the assigned Approver that you are putting in the section marked in red in your picture an internal or external user?
@Pstork1 Thanks for quick reply. Yes, I already checked junk mail and both focused and other tabs. No email is found. We have Office 365 and the "assigned to" is an internal user.
Have you checked the users involved to make sure their UPN and eMail addresses are the same? Also check if they aren't that you are filling in the Assigned to field with their email. I've never seen a situation where the Approvals flow didn't send an email. if Notifications was enabled. If its turned off then yes, it only goes to the Flow approvals tab. But you said notifications was enabled.
Are you using a dynamic content in the "Assigned To" field? Be sure that you using de correct field (ex: Author.Email)
I avoid to use templates. try to recreate one from blank with the same actions!
@Pstork1 Yes, both same email address. I tried 3 different internal users with same results.
@mdeleuterio I entered the email manually but I'll try dynamic content. And, I also tried both template and custom flow. Edit: I tried dynamic content with the same result. Now, I'm wondering if it has anything to do with ATP (Advanced Threat Protection) - it was enabled recently. I'll reach out to others.
When you say you entered the email manually, do you mean you typed in the actual email or that you typed in the name of the field? Typing in an actual email will work, typing in the name of the field won't. For that you need to insert through dynamic content.
Hi @Tamras ,
Approval actions are always working fine on my side.
As you mentioned that “I found the sent/received under Approvals dashboard but no associated email”, I assume that the approval action itself is working properly, there might be some blocks on your email box.
Please check if there are any special restrictions on the email box and try again.
After the running the flow, does it succeed? Does the output shows the "Assigned to" field, as empty?
Have you tried to put the email in a variable and insert the variable in the "Assigned to"?
@mdeleuterio it succeeded after I reply through the Approvals page (not through email) and the output shows the email address. I also tried using variable. @v-yamao-msft is probably correct about it being Outlook/Exchange issue. I don't have access to reports so I can only rely on our Exchange admin. He is still looking into it. If we can't figure this out I'll submit a ticket. At the mean time, I'm using the 'send email' action.
Hi @Tamras ,
Thanks for updating.
Please share with us if you get any updates on this issue.