Custom Connector - Swagger Editor won't load

[ElinnaCheah]

Hi Community

I have been successfully working on custom connectors for the last few months using the Swagger Editor.

Then I went on holiday, when I got back, the Swagger Editor won't load. 

I just get a blank screen.

Does anyone what the issue is or where I can go for further assistance? I've tried different browsers and different connectors but nothing seems to make it load.

Thank you in advance for your advice

[MarkPP]

I am getting the same issue and it was fine previously. I think you might need to raise a support ticket. I am going to do the same.

[Syndicate_Admin]

Same, the swagger editor does not work for me since this morning.

Yesterday it was working fine. I'll probably raise a support ticket too.

[ElinnaCheah · Accepted solution]

The swagger editor is now working again. 

Note: i didn't end up logging a ticket

[MarkPP]

@ElinnaCheah I raised a support ticket and they could replicate it. They released a fix at the end of the week 🙂

[ElinnaCheah]

Thank you so much. I tried three times to raise a ticket but something kept happening. I appreciate you doing it!