cancel
Showing results for 
Search instead for 
Did you mean: 
Reply
Memorable Member
Memorable Member

Get Connector of Flow Management

Issue : The ourput of ' Get Connector ' action of the Flow Management controller is no-good.

1.jpg

a output from Get Connector action

Connector Name = dynamicSchema

Connector Display Name = <blank>

Connector Runtime Uri = <blank>

 

My scenario:

Share the connector informations I'm using

 

How can I get do?

 

1 ACCEPTED SOLUTION

Accepted Solutions
Community Support
Community Support

Hi @yoshihirok ,

 

Thank you for your feedback, this is some of the connectors that are not commonly used, so there is a lack of attention.

I tested Get Connector, which is consistent with what you described. Connector Name contained in Returns is always dynamicSchema, which does not seem to be the value we expect to get.

There are even some connector outputs that only contain Connector Name, as below:20.PNG

I will feedback this to MS Flow on my side. If you want to get more specific information from this action, please also consider giving feedback here.

 

Best Regards,

Community Support Team _ Barry
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

View solution in original post

2 REPLIES 2
Community Support
Community Support

Hi @yoshihirok ,

 

Thank you for your feedback, this is some of the connectors that are not commonly used, so there is a lack of attention.

I tested Get Connector, which is consistent with what you described. Connector Name contained in Returns is always dynamicSchema, which does not seem to be the value we expect to get.

There are even some connector outputs that only contain Connector Name, as below:20.PNG

I will feedback this to MS Flow on my side. If you want to get more specific information from this action, please also consider giving feedback here.

 

Best Regards,

Community Support Team _ Barry
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

View solution in original post

Hi @v-bacao-msft , thank you for your reply, and feed this issue to Microsoft Flow team

 

and I hope to output the version of each controller,

for notify the version update when the contoller is updated.

 

Regards,

Helpful resources

Announcements
New Super Users

Meet the Power Automate Super Users!

Many congratulations to the Season 1 2021 Flownaut Crew!

New Badges

New Solution Badges!

Check out our new profile badges recognizing authored solutions!

MPA Community Blog

Power Automate Community Blog

Check out the community blog page where you can find valuable learning material from community and product team members!

Users online (11,093)