Action Configuration Error 400

[DJGR]

I am getting a code 400 action configuration error that is causing my flow to fail. The support article says 'The error message should specify how to correct the failure.'

We've had two of us looking into this but cannot figure out where to enter what the error is telling us: A value must be provided for item. clientRequestId: 8c2494c0-e92d-4029-9397-64536e019b4e

As far as we can see every item has a value against it. Any help would be much appreciated.

[v-zhos-msft]

Hi @DJGR ,

Could you please share a screenshot of your flow's configuration?

Then I can do more analysis for you.

As the error message said, you have entered incorrect value in the action.

Best Regards,

Community Support Team _ Zhongys

If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

[DJGR]

Hi @v-zhos-msft ,

I am very new to both Docparser and Flows, so am still figuring out where all the connections are. This flow was set up by someone else who was an expert and I have been asked to figure it out and I am really stuck where to look. Thank you for your help. Is this what you are after?

[DJGR]

Hi @v-zhos-msft,

I also took these screenshots in case you would find them helpful, I just had to black out personal details.

[v-zhos-msft · Accepted solution]

Hi @DJGR ,

As the pic shown, in some columns, the value type is Json, like: {"key_0":"xxxx"}.

You should get the "xxxx" value in the columns.

I have made a test on my side, please take a try with the following workaround:

You should use the values like 'Compose 3' in the flow.

Best Regards,

Community Support Team _ Zhongys

If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.